Work Equipment Safety (PUWER)
Check equipment before use and report defects, keep guards as intended, clear a blockage only if authorised and after isolating it as instructed, cut noise and vibration risks, and keep clear of reversing vehicles.
Content last checked on 19 November 2026.
About this course
- Who it is for
- Anyone the council asks to use or work near its equipment and vehicles, such as grounds, depot and maintenance staff, caretakers, hall staff and supervisors. It is also for volunteers and councillors who help at council activities.
- How long it takes
- About 63 minutes if you read the lessons, or 68 if you listen to them, including the final assessment. An estimate from the course’s length, not yet timed with learners.
The lessons
- What counts, and who may use it
- Check it before you use it
- Guards, controls and using it as intended
- Before you clear, adjust or clean
- Noise and vibration
- Lifting equipment
- Vehicles, reversing and working with a banksman
- When something goes wrong
What you will be able to do
- Know what counts as work equipment, including your own tools and machines the council hires.
- Keep to equipment you are trained and authorised for, and ask before using a machine or model that is new to you.
- Know the checks to make by eye before you use equipment, and that they do not replace the council’s inspection.
- Keep faulty equipment, or equipment past its inspection date, out of use and report it.
- Keep guards and safety devices in place, and stop if one fails, someone comes near or conditions change.
- Know the rule for clearing a jam: only within your instructions, with the power securely cut off and every part stopped.
- Spot early signs of harm from noise and vibration, such as ringing ears or numb fingers, and report them promptly.
- Know what to do when hearing protection fails: leave the noise with it on, report it, and wait for the council’s word.
- Leave lifting equipment out of use if its examination is unconfirmed, a fault is suspected or the load is over its limit.
- Keep clear of reversing vehicles, and know when a vehicle guided by a banksman must stop and when it may move again.
- Call 999 from a safe place at once in an emergency, alert first aid separately, and attempt no untrained rescue.
- Report an incident clearly, and keep the equipment out of use until an authorised person confirms it can restart.
The law and guidance it rests on
The sources the course’s content was checked against, each with what it asks of a council and a link to the official text.
Provision and Use of Work Equipment Regulations 1998 (PUWER)
An employer must make sure work equipment is suitable, maintained and inspected where needed, and used only by people given the information, instructions and training to use it.
Health and Safety at Work etc. Act 1974
An employer must protect the health, safety and welfare of its staff and of others its work affects; staff must take reasonable care and co-operate.
Lifting Operations and Lifting Equipment Regulations 1998 (LOLER)
Lifting equipment must be thoroughly examined by a competent person at set intervals, and kept out of use when an examination finds a dangerous defect.
Control of Noise at Work Regulations 2005
An employer must assess and reduce the risk from noise, make hearing protection available or provide it as exposure rises, and mark hearing protection zones.
Control of Vibration at Work Regulations 2005
An employer must assess and reduce the risk from vibrating tools, and arrange health checks for staff at risk.
HSE: a guide to workplace transport safety (HSG136)
HSE’s guidance on keeping people and vehicles apart, avoiding reversing where possible, and when and how to use a banksman.
See Pavryn Learn for yourself
A demonstration takes you through a learner’s course and the officer’s reports.