Risk Assessment and Managing Contractors
Assess the risks of a council task or event, choose controls in the right order, record and review them, check a contractor’s own assessment, and carry out the council’s duties as a client under CDM 2015.
Content last checked on 18 November 2026. Some of its sources were checked again on 19 November 2026.
About this course
- Who it is for
- Officers who write or review risk assessments and bring in contractors, and the managers and councillors on committees that commission work.
- How long it takes
- About 74 minutes, including the final assessment. An estimate from the course’s length, not yet timed with learners.
The lessons
- Whose assessment, and which one
- Hazards, and who might be harmed
- Judge the risk and choose controls
- Record, share and review
- Events and hirers: sharing the responsibility
- Bringing in a contractor and having building work done
What you will be able to do
- Know whether a job is covered by an existing assessment, needs a new general one, or needs a specialist one referred on.
- Write or review risk assessments only within the authority the council gives you, with the skills or supervision the task needs.
- Find hazards by looking at how the work is really done and talking to the people who do it.
- Set out who could be harmed and how, including the public, volunteers, contractors, workers under 18 and new or expectant mothers.
- Judge how likely and how serious harm could be, and whether the controls already in place really work.
- Choose controls in the order the law and HSE set, removing the risk where you can and using protective equipment last.
- Record each action with a named owner and a date, and tell the people affected what applies to them.
- Review an assessment after a significant change, an incident or a near miss, before the work carries on.
- Agree who does what with hirers and event contractors when the council runs an event or hires out a hall.
- Choose a contractor with checks in proportion to the risk, and give them the council’s risk information, asbestos above all, early.
- Check that a contractor’s documents fit the actual job and site, and keep the work paused until any gap is resolved.
- Know the council’s duties as client under the construction safety rules (CDM 2015), and when a project must be notified to HSE.
The law and guidance it rests on
The sources the course’s content was checked against, each with what it asks of a council and a link to the official text.
Management of Health and Safety at Work Regulations 1999
An employer must make a suitable and sufficient assessment of risks, record the significant findings where it has five or more employees, and review it.
Health and Safety at Work etc. Act 1974
An employer must protect the health, safety and welfare of its staff and of others its work affects; staff must take reasonable care and co-operate.
Construction (Design and Management) Regulations 2015 (CDM 2015)
A council that has building work done is a client: it must make suitable arrangements, give information to designers and contractors, and appoint a principal designer and principal contractor where more than one contractor is involved.
Control of Asbestos Regulations 2012
Whoever manages a non-domestic building must find out about asbestos in it and tell anyone who may disturb it.
Regulatory Reform (Fire Safety) Order 2005
The responsible person for premises must carry out a fire risk assessment and keep fire precautions in place.
HSE: risk assessment, the steps needed to manage risk
HSE’s plain guide to identifying hazards, deciding who might be harmed, choosing controls and recording them.
See Pavryn Learn for yourself
A demonstration takes you through a learner’s course and the officer’s reports.